Antari Deep Violet UV Paint - 1 Gallon
The Antari DFX-VL1GL-DVL is a 1 Gallon container of Deep Violet UV Fluorescent Paint. Special features include Fluorescent pigment, water-based solution, and are acrylic color balanced.
Antari DFX-VL1GL-DVL 1 Gallon Deep Violet UV Paint Specifications:
Visible and Blacklight Applications:
- Most Powerful Luminescence available
- Daylight to blacklight super saturated pigmentation.
- Recommended 365nm UV "Blacklight" source.
- Recommended painting under UV Blacklight source and proper UV application techniques are used to ensure the creation and development of expected fluorescent visual effects
Surface Preparation:
- All surfaces to be painted must be entirely free of dust, dirt, oil, grease and other contaminants
- Properly prime the clean, dry surface with a "white" acrylic, water base primer and allow the primer to dry
- Always ensure adequate ventilation when painting
- Lower temperatures and higher humidity will lengthen the dry and cure times of primers and paints
- Note : If a "whiter" base coat is desired, paint over the primer coat with a Flat Latex White Paint or a Matte, White Acrylic
Application Conditions:
- Keep away from direct sunlight as the fluorescent pigments will fade in approximately three months or less, when exposed to sunlight
- Recommended application temperature should not be below 54 degrees F or above 86 Degrees F
Application:
- The DarkFX Fluorescent Pigments can be brushed, rolled, or sprayed onto any paintable, properly primed, interior surface
- High concentrations of color allow the DarkFX Fluorescent Pigments to be blended and diluted using distilled water
- Do not over diluting, over diluting will decrease adhesion
- Note : When spraying, use a properly-fitted, NIOSH approved respirator per the manufacturers instructions
Mixing and Tinting:
- Arcylic paints can be used to deepen or lighten the color as well as modify consistency. Always test modified paint under daylight and blacklight conditions before applying.
Dry Times:
- DarkFX UV Paints dry-to-touch is approximately 30 minutes at 70 degrees F and 50% relative humidity
- Recoat wait time should be approximately 1 hour at 70 degrees F and 50% RH
- Note: Lower temperature and/or higher humidity will lengthen the dry and cure times
- Higher temperatures and/or lower humidity will speed up the dry and cure times
Coverage:
- One Gallon/3.78 liters will cover approximately 250 to 300 square feet/23 to 27 square meters
- Approximately 1.5 mils dry film thickness per coat
- A Minimum of 3 mils dry film thickness is required for full color development and saturation
- Note: Fluorescent pigmented coatings are translucent and do not exhibit the same "hiding" characteristics as traditional paints
Clean Up:
- Clean brushes, rollers, tools, and all other equipment with soap and warm water immediately after use
- Do not reuse containers and properly dispose of empty containers
Handling & Storage:
- Close containers tightly when not in use
- Store paint in a cool, dry place, and keep away from direct sunlight
- Protect from freezing
- If paint becomes frozen, allow the paint to completely thaw and come to room temperature, then mix thoroughly before use
Disposal:
- Dispose of unused or unwanted products in accordance with local laws regulating water-based coatings
Healthy and Safety:
- Use in a well ventilated area
- Avoid contact with eyes
- Wash hand thoroughly with soap and warm water after use
- Do not take internally
- When spraying or sanding, use a properly-fitting NOISH approved respirator per the manufacturers instructions
- Warning! If you scrape, sand, or remove OLD paint, you may release lead dust. Lead is toxic.
- EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE
- Wear a NOISE-approved respirator to control lead exposure
- Clean up carefully with a HEPA vacuum and a wet mop
- Before you start, find out how to protect yourself and your family by contracting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. Antari Dark FX Acrylic paints are free from lead
Skin Contact:
- Thoroughly wash with soap and warm water before the coating dries
- Individuals with sensitive skin may require gloves
Eye Contact:
- Rinse with clean water for 15 minutes, seek medical attention
Inhalation:
- To help prevent irritation, use only in well-ventilated areas
- If irritation occurs, move to fresh air, if irritation persists, seek medical attention
Ingestion:
- Do not induce vomiting, seek medical attention
Warranty:
- This product will perform as claimed if directions are followed
- Directions are as complete as possible, but cannot encompass all conditions, applications, techniques, and/or surfaces, which are beyond our control
- Warranty is limited to replacement or refund value of product actually used, if such product proves defective within two years of manufacture
- No other warranty is expressed or implied
Antari Deep Violet UV Paint - 1 Gallon
Sale price$199.00